Controlled automatic generator

Automatic generator for diesel generator set control:

Interface:

Communication protocol:

Communication port, MODBUS RTU ESCLAVO, for communication with the central control center

Ability to set communication parameters, such as the number of slave stations, speed (bps), comparison and quantity of station positions.

Communication channel: RS-485

Diesel generator automatic transmission module

The control module will be installed on the automatic transmission meter.

Equipped with a communication port, it can issue supervision instructions to the control center.

The electronic automatic transmission module has two startup attempts, which will be paired with an electric thermal magnetic switch.

When the main network is reset to the normal conditions of voltage (programmable), an adjustable time schedule of 0 to 15 minutes will be activated, and at the end of this period, it will be activated on the switch for load transfer to the normal source.

The generator set will remain in operation because once load transfer begins, a 0-15 minute adjustable timer will start, and once the scheduled time is over, a signal will be issued to stop the generator set from operating.

If the timer fails to connect to an emergency situation and there is a normal system, the timer will be connected using a bridge to perform load transfer work.

The transmission board presents a data table. This data table is generated based on polycarbonate film, and installation diagrams are drawn in different colors on the film.

Each switch has two LED lights - red and green, with a minimum diameter of 4mm, and corresponding legends.

There is a lamp testing system that utilizes button switches and non return diodes.

The adhesive film is applied to polished aluminum plates and will be applied to blind doors of automatic transmission panels.